Electrolux EAW05E3AJW Instruction Manual page 27

51 electrolux how to use
To use fan feature
Press "Fan button" and choose auto.
Fan starts at High Speed and adjusts
to a slower speed as the room
temperature dictates. For example, if
the room doesn't get too warm, it will
stay at the slowest speed. If the room
temperature rises quickly, such as a
door being opened, it will
automatically go to the highest speed.
The fan speeds will re-adjust back to
the slowest speed as the room returns
to the original set temperature. Press
either the fan slower or fan faster
button to adjust the fan speed
manually.
To operate on fan only
Press mode button an choose fan
only.
Use this function only when cooling is
not desired, such as for room air
circulation or to exhaust stale air on
some models. (Remember to open
the vent during this function, but keep
it closed during cooling for maximum
cooling efficiency.) You can choose
any fan speed you prefer. (Except
"Auto Fan") During this function, the
display will show the actual room
temperature, not the set temperature
as in the cooling mode.
8.000 y 12.000 btu/h 5.000 btu/h
models models
To use energy saver feature
Press mode button and choose
energy saver.
In this mode, the fan will continue to
run for 1 minute after the compressor
shuts off. The fan then cycles on for
20 seconds at 10 minute intervals
until the room temperature is above
the set temperature, at which time the
compressor turns back on and cooling
starts.
Delay stop/start feature
Press timer button and press
temp/timer set button.
To adjust timer setting, tap or hold the
UP arrow ( ) or the DOWN arrow ( )
to change delay timer at 0.5 hour
increments, up to 10 hours, then at 1
hour increments up to 24 hours. The
control will count down the time
remaining until start (8, 7.5, 7, etc.).
The Delay Start mode automatically
selects cooling with maximum Fan
Speed. The temperature maintained
will be the same as previously set. To
change the set temperature, press
"COOL" then Up or Down arrows until
the desired temperature is indicated
on the display. After 5 seconds, the
control will automatically change the
display back to the hours remaining
until the unit will start/stop. Turning
the unit "ON" or "OFF" at any time will
cancel the Delay Start/Stop function.
The Delay Start/Stop Feature will
work until the unit either starts or
stops. Once that happens, the above
steps have to be repeated again.
how to use electrolux 52
For Delay Stop, the unit must be in
the On position.
For Delay Start, the unit must be in
the Off position.