Disassembling The Slide; Disassembling The Top Part Of The Base - Siemens SL 10 Service Manual

3.2.3Disassembling the Slide

1. Unscrew the countersunk-head screw (A)
2. Next, release the lower catch (B)
3. Then release the six lateral catches (1-6 )
1.
After releasing the catches, remove the bottom part of the slide.
2.
Now remove the MMI board from the bottom part of the slide by
raising the board (1.) and pushing it toward the keypad (2.).
Attention: Do not crease or damage the flexible cable
on the lower side of the MMI.
1. Finally, remove the dust protection frame, the keypad
mat and the loudspeaker from the top part of the slide.
You now have disassembled the slide completely.

3.2.4Disassembling the Top Part of the Base

1. First remove the microphone holder and the flexible
microphone cable attached to it from the microphone
housing.
1. Then detach the flexible keypad cable from the ZIF-plug (ZIF=Zero Insertion Force).
To do so, please first open the retaining clip and pull out the cable afterwards.
2. Remove the ringer gasket.
3. Now remove the four torx flat-head screws on the screen lid and the two torx countersunk-
head screws on the side of the microphone.
Service Manual SL10
Sm_sl10_lvl2_v11.doc
Private Communication Systems
V1.1
Page 8 of 23
Mobile Phones
2.
1.
6
5
4
A
B
3
2
1
PN MP ST
R. Fleuren
05/98