Assembling The Top Part Of The Base; Assembling The Slide - Siemens SL 10 Service Manual

3.3.2Assembling the Top Part of the Base

1. First insert the microphone into the top part of the base.
2. Now insert the control module, mount the screen lid and screw in
the six screws.
3. Mount the ringer gasket.
4. Connect the flexible keypad cable to the plug on the control
module and press the retaining clip
5. Finally, mount the flexible microphone cable onto the
microphone housing

3.3.3Assembling the Slide

1. First insert the loudspeaker and the keypad mat into the
device.
Insert the dust protection frame into the top part of the slide.
1.
Caution!
- The copper side must point toward the housing.
- The strap must be bent in a way that it lies on the keypad
mat (see figure beside).
1. Thread the flexible cable of the MMI into the lower
part of the slide, mount the MMI board and lock it in
place. Pull the flexible cable carefully out all the way.
Caution!
Do not crease or damage the flexible cable e.g. like
shown in the figure beside.
1. With its top edge leading, insert the lower part of the
slide into the top part of the slide, letting the catches
snap into place one after the other from top to bottom.
2. Finally, screw in the torx countersunk-head screw.
Service Manual SL10
Sm_sl10_lvl2_v11.doc
down
.
V1.1
Page 11 of 23
Private Communication Systems
Mobile Phones
PN MP ST
R. Fleuren
05/98