Page 1
Blower MODEL MT400 006292 DOUBLE INSULATION I N S T R U C T I O N M A N U A L WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
SPECIFICATIONS Model MT400 Capacities Max. air volume 1.3 - 2.4 m /min. 8,500 - 16,000 No load speed (min Overall length 428 mm Net weight 1.3 kg Safety class • Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
GENERAL SAFETY RULES GEA001-2 WARNING: Read all instructions. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. The term “power tool” in all of the warnings listed below refers to your mains- operated (corded) power tool or battery-operated (cordless) power tool.
Page 4
Remove any adjusting key or wrench may affect the power tools operation. If before turning the power tool on. A wrench damaged, have the power tool repaired or a key left attached to a rotating part of the before use. Many accidents are caused by power tool may result in personal injury.
ADDITIONAL SAFETY RULES ENB096-1 Always use protective goggles, a cap and mask Never block suction inlet and/or blower outlet. when using the blower. Increased motor revolution may cause danger- ous fan breakage. Never point the nozzle at anyone in the vicinity when using the blower.
FUNCTIONAL CAUTION: DESCRIPTION • Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. Switch action 006293 CAUTION: • Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the “OFF”...
Installing the sash nozzle 006296 Sash nozzle is convenient for operation in a sash rail, corner or tight place between cabinets. Secure the sash nozzle by inserting it into the nozzle from the back of the nozzle. 1. Nozzle 2. Sash nozzle Install the nozzle with the attached sash nozzle.
Page 8
Makita Corporation Anjo, Aichi, Japan 884601-226...
Need help?
Do you have a question about the MT400 and is the answer not in the manual?
Questions and answers