Power Pad Assembly Replacement - JVL Echo Technical Support Manual

To Purchase This Item, Visit BMI Gaming | www.bmigaming.com | (800) 746-2255 | +1.561.391.7200

Power pad assembly replacement

11.
power paD assembly replacemenT
1. Turn off the countertop and disconnect the AC power supply.
Following two steps are for security purposes only (not to let coin from cashbox get into ma-
chine).
2. Open the lock and tilt the top of the Back Door towards you to remove it completely (see Fig. 1
on page 26 for details).
3. Remove the freely installed Cashbox by lifting upwards, then pulling it towards you (see Fig. 2
on page 27 for details).
4. Unscrew six Tapping Screws #8 x 3/8" and carefully pull the Power Pad Assembly upwards to
gain access to the Power Pad USB cable (see Fig. 34 on page 47 for details).
5. Disconnect the Power Pad USB cable connector from the Joystick Board (see Fig. 35 on page 47
for details).
6. (Optional) If equipped with the RFID Board, disconnect the RFID cable connector from the Joy-
stick Board (see Fig. 36 on page 48 for details).
7. Replace the old Power Pad Assembly with the new one.
8. Reassemble the countertop by following the previous steps in reverse order.
NOTE: For part numbers see Appendix B
16
Copyright © 2011 JVL Labs All Rights Reserved