Bill Acceptor Replacement - JVL Echo Technical Support Manual

To Purchase This Item, Visit BMI Gaming | www.bmigaming.com | (800) 746-2255 | +1.561.391.7200

Bill acceptor replacement

8.
bIll accepTor replacemenT
1. Turn off the countertop and disconnect the AC power supply.
2. Open the lock and tilt the top of the Back Door towards you to remove it completely (see Fig. 1
on page 26 for details).
3. Remove the freely installed Cashbox by lifting upwards, then pulling it towards you (see Fig. 2
on page 27 for details).
4. Unscrew 4 Machine Screws:
(Two- #8-32 x 1-1/4" and two #8-32 x 3/8") and open the monitor to gain access to all electronic
components (see Fig. 3 on page 28 and Fig. 4 on page 29 for details).
5. Press on the snaps of the Inner Cover to unlock them. Tilt the cover towards you, and then slide
the Inner Cover upwards. Move it along the Monitor Stopper Cable and set it aside (see Fig. 5 on
page 30 for details).
6. Unplug the following connectors from the CPU Box:
• LVDS cable
• Touch screen cable
See Fig. 20 on page 36 for details
7. Unscrew one Hex Nut #8-32 and free the Touch Screen USB cable from the clamp (see Fig. 21 on
page 39 for details).
8. Disconnect the Monitor Door Stopper Cable from the Monitor by unscrewing one machine
screw #8-32 x 3/8" (see Fig. 22 on page 40 for details).
9. Remove and set aside the Monitor assembly by lifting upwards.
10. Disconnect the following connectors from the amplifier PCB:
• Upper Tweeters connector (1)
• Mid-range speakers connector (2)
• Subwoofer speakers connector (3)
• CPU Box audio cable connector (4)
• Power cable connector (5)
See Fig. 23 on page 44 for details
11. Unscrew one Hex Nut #8-32 and disconnect the Bill Acceptor Ground cable from the stud
(PEM) (see Fig. 24 on page 41 for details).
12. Remove the Bill Cassette (see Fig. 25 on page 41 for details).
13. Remove the Bill Acceptor Cover by sliding it upward (see Fig. 26 on page 42 for details).
14. Unscrew one Machine Screw #8-32 x 3/8" (see Fig. 27 on page 42 for details).
15. Slide the Bill Acceptor and bracket upwards and remove by tilting them towards you to gain
access to Bill Acceptor connector (see Fig. 28 on page 43 for details).
16. Disconnect the BA Harness connector from the Bill Acceptor (depending on the type of Bill
Acceptor).
17. Set aside the Bill Acceptor with Bill Acceptor bracket.
12
(6) HNS-CT09-780
(3) HNS-CT09-716
Copyright © 2011 JVL Labs All Rights Reserved