Table of Contents
Advertisement
OPERATION
Oven Control, Clock and Timer
Your new control has a series of tones
that will sound at different times. These
tones may sound while you set the
control for an oven function, or at the
end of the oven function. It will also alert
you that there may be a problem with
the functions. Below are the types of
tones and a brief description of each,
TONES
WHILE SETTING
THE
CONTROL
When you press a touch
pad you will hear a beep. This beep will
let you know you have placed enough
pressure on the pad to activate it. (The
arrow pads do not beep.)
END OF TIMED
CYCLE TONE --
At the end of a timed cooking function,
you will hear 3 short beeps followed by
1 beep every 6 seconds, This beep will
continue to sound every 6 seconds,
until the CLEAR/OFF
pad is pressed
or you may select the special feature to
cancel this 6 second beep from
sounding at the end of future cycles,
TO CANCEL
THE 6 SECOND
BEEP
1. Press and hold the BAKE and
BROIL pads, at the same time
for 3 seconds, until the display
shows I_SF_.
2. Press the KITCHEN
TIMER
ON/OFF pad. The display will show
"CON BEEP" (continuous beep).
3. Press the KITCHEN
TIMER
ON/OFF pad again. The display will
show "BEEP"
(beep canceled).
4, Press the START pad to cancel the
6 second beep and leave the
special feature mode.
If you would like to return the 6 second
beep, repeat steps above until the
display shows your choice and press
the START pad.
ATTENTION
TONE -- This tone will
sound if you make an error or an
oversight is made while setting an oven
function.
Examples would be:
a, Setting a clean cycle and the oven
door is not properly closed.
b, Setting function and not pressing the
START pad.
e. Pressing an additional function pad
without first setting a temperature or
time.
Any of these can be quickly identified
by watching the display.
PREHEAT
TONE -- When you set an
oven temperature, the oven
automatically starts to heat. When the
temperature inside the oven reaches
the temperature you have set, a tone
will sound to let you know the oven is
ready for baking.
If you set an oven function and the
control beeps while the display is
flashing "F" and a number or letter
such as "F-4" or "Fr' there may be a
problem with the control or oven.
Simply press the CLEAR/OFF
pad and
wait about an hour. Try setting the
function again. If the code repeats, write
down the flashing code and call for
service. Teit the technician what code
was flashing.
9
Advertisement
Table of Contents
