Date And Time Setting; Clear Hard Disk - RHINO H.264 Network DVR User Manual

2.4 Date and Time Setting

Before operating your DVR, please set the date and time on your DVR FIRST.
Note: Please DO NOT change the date or time of your DVR after the recording
function is activated. Otherwise, the recorded data will be disordered and
you will not be able to find the recorded file to backup by time search. If
users change the date or time accidentally when the recording function is
activated, it's recommended to clear all HDD data, and start recording
again.
Note: For the first time to use the DVR, please power it on for at least 48 hours
continuously after the date & time is set correctly. It helps to prevent DVR
time from resetting after the disconnecting of DVR power. If the DVR time
resets after the disconnecting of DVR power, for example, caused by a
power outage, the battery might run out and please replace the battery as
described in "APPENDIX 5 DVR BATTERY REPLACEMENT" at page 52.
Right-click to enter the DVR password with the password keypad. The default
administrator password is 0000. The status will be changed from
(administrator). Then, right-click to show the main menu, and select "QUICK START"
"TIME SETUP" to set the date & time.
GENERAL
TIME SETUP
EXIT

2.5 Clear Hard Disk

It's recommended to clear all data in the hard disk for the first time to user this DVR to
ensure the recorded data are not mixed with other data previously saved in the same
hard disk.
Right-click to show the main menu, and select "SYSTEM"
"CLEAR HDD". The DVR will reboot when HDD data are cleared.
QUICK START
DATE
TIME
10
2009 / NOV / 17
15 : 35 : 53
"SYSTEM INFO"
CONNECTION AND SETUP
(key lock) to