Dvr Power On - RHINO H.264 Network DVR User Manual

For DVR PIN configuration, please refer to "APPENDIX 6 PIN
CONFIGURATION" at page 53. For connection details, please check with your
installer.
STEP 5: Set the speed dome camera at the DVR side.
Go to "ADVANCE CONFIG"
a) Select the device to "PTZ".
b) Set the ID to the value the same as the one set in the speed dome camera.
The default ID of the camera is 000.
c) Select the protocol to "NORMAL".
d) Set the baud rate to the value the same as the one set in the speed dome
camera. The default baud rate of the camera is 2400.
CANERA
DETECTION
ALERT
NETWORK
SNTP
DISPLAY
RECORD
REMOTE
EXIT

2.3 DVR Power On

This device should be operated only with the type of power source indicated on the
manufacturer's label. Connect the indicated AC power cord to the power adapter, and
plug into an electrical outlet. The power LED will be on.
Note: Before the DVR is powered on, make sure the cameras are connected and
power-supplied for the detection of the camera video system to be correct,
and check the monitor (either LCD or CRT monitor) is connected to the DVR
before the DVR is powered on for correct video output detection.
Note: To ensure that your DVR works constantly and properly, it's recommended
to use an UPS, Uninterruptible Power Supply (Optional), for continuously
operation.
"REMOTE" to set the speed dome camera.
ADVANCE CONFIG
CH1 CH2 CH3 CH4 CH5 CH6 CH7 CH8 CH9 CH10 CH11
DEVICE
ID
PROTOCOL
RATE
9
CONNECTION AND SETUP
PTZ
000
NORMAL
2400