SETTING UP YOUR MICROSCOPE
After opening the styroform container, check that you have the following parts and
accessories.
Microscope stand complete
●
Binocular or Trinocular Viewing head
●
WF10x Eyepiece(s) (pair for Binocular or Trinocular head)
●
Objectives in plastic container
●
White diffusion filter
●
AC/DC adapter 100-240VAC 50/60Hrz
●
C-Wrench for tension control
●
Immersion oil in container
●
Dust cover
●
Instruction manual
●
For trinocular viewing head, C-mount tube and Photo tube
●
1.
Place the stand on a level, stable surface. The microscope is easiest to use
when you face the front of the stage.
2.
Loosen the head locking thumb screw provided on the side of the arm, and put
the viewing head onto the receptacle. The head can turn full 360°inside the re-
ceptacle. This permits observation from any direction. Tighten the thumb screw
to fix the head in any position you desire.
3.
Put the eyepiece(s) into the eyepiece tube(s), being careful not to touch the
lenses.
4.
Take out the objectives from the plastic containers and screw them into the re-
volving nosepiece from the lowest magnification to the higher one in clockwise
direction as you face the upside of the microscope.
5.
Turn the switch off(O) and connect the AC/DC adapter to electric power sup-
ply.
Eyepieces
Objectives
C-wrench
- 3 -
C-mount tube
(for trinocular model only)
Photo tube
(for trinocular model only)
AC/DC adapter
Stand
Viewing head