The electrically-operated windows are controlled by switches in the driver's door as shown in the illustration above. The starting (ignition) switch must be ON (intermediate position I) for the electrically-operated windows to

function.

To lower : press down on the front edge of the button

To raise : pull up on the front edge of the button.

NOTE:

• Auto-down function (driver's window only): The window can be opened completely by pressing the front part of the switch lightly and releasing it immediately. The window can be stopped by pressing the button again. If

the button is held down, the window will be lowered until the button is released.

• The power window motors have an overload protecting circuit breaker which is activated when an object blocks a window. Should this occur, remove the object and wait 20 seconds for the circuit breaker to reset. The

power windows should then function.

Cut-out switch for rear windows

If your car is equipped with electrically operated rear door windows, this function can be disabled by a switch located on the driver's door (see illustration).

ON The rear door windows can be raised or lowered with the respective door switches as well as with the switches on the driver's door armrest.

OFF The rear door windows cannot be raised or lowered with the respective door switches but instead only with the corresponding switches on the driver's door armrest.

WARNING! Remove the starting (ignition) key when children are left unattended in the vehicle.

Make sure that children's hands are clear before raising the windows.

.../PageContent.asp?PageID=1049&U={A308DBD7-11E2-6E5B-32ED-82405EEBA5B1}&V={CAB0F6D6-415D-C205-E1E4-41F3DD1CF3F0}&T=3&C=230,229,233,239,225,799,825,409,10 12/30/02

Page 9 of 9