Installation Instructions - AEG HC452020EB User Manual

You cannot activate the
outer ring.
The sensor fields be-
come hot.
There is no acoustic sig-
nal when you touch the
panel sensor fields.
comes on.
comes on.
and a number come
on.
If you tried the above solutions and can-
not repair the problem, speak to your
dealer or the customer service. Give the
data from the rating plate, three digit
letter code for the glass ceramic (it is in
the corner of the glass surface) and an
error message that comes on.

8. INSTALLATION INSTRUCTIONS

WARNING!
Refer to "Safety information"
chapter.
Before the installation
Before the installation of the appliance,
record the information below from the
rating plate. The rating plate is on the
bottom of the appliance casing.
• Model ...........................
• PNC .............................
• Serial number ....................
Problem Possible cause
The cookware is too
large or you put it too
near to the controls.
The signals are deactiva-
ted.
The Automatic Switch
Off operates.
The Child Safety Device
or the Lock function op-
erates.
There is an error in the
appliance.
Make sure, you operated the appliance
correctly. If not the servicing by a cus-
tomer service technician or dealer will
not be free of charge, also during the
warranty period. The instructions about
the customer service and conditions of
guarantee are in the guarantee booklet.
8.1 Built-in appliances
• Only use the built-in appliances after
you assemble the appliance into cor-
rect built-in units and work surfaces
that align to the standards.
8.2 Connection cable
• The appliance is supplied with the
connection cable.
• Replace the damaged mains cable
with a special cable (type H05BB-F
Tmax 90°C; or higher). Speak to your
local Service Centre.
ENGLISH
Remedy
Activate the inner ring
first.
Put large cookware on
the rear cooking zones if
necessary.
Activate the signals (refer
to "OffSound Control").
Deactivate the appliance
and activate it again.
Refer to the chapter "Dai-
ly Use".
Disconnect the appliance
from the electrical supply
for some time. Discon-
nect the fuse from the
electrical system of the
house. Connect it again.
If comes on again,
speak to the service cen-
ter.
13