Polaris Ranger 6x6 700 EFI 2009 Owner's Manual page 40

Park Brake Lever
To help prevent the vehicle from rolling, engage the park brake when
parking the vehicle. When the park brake is fully engaged and the park
brake indicator is illuminated, engine speed is limited to 1300 RPM in
all gears, including neutral. If throttle is applied, this limiting feature
prevents operation, which protects the park brake pads from excessive
wear. This feature will not operate properly if the park brake connector
or switch (under the hood) malfunctions or becomes disconnected, or if
the switch has moved. Check for disconnection, then see your dealer
promptly if this feature fails to operate properly.
Inspect and adjust park brake cable tension after the first 25 hours of
operation and every 100 hours thereafter to ensure proper cable tension.
See page 87.
Always apply the service brakes
before engaging or releasing the
park brake.
1. Apply the brakes.
2. Pull the park brake lever
downward as far as possible.
3. To release the park brake,
apply the brakes. Press the
park brake release inward
and move the lever upward as
far as possible.
Operating the vehicle while the park brake is engaged could cause loss of
control and result in serious injury or death. Always disengage the park brake
before operating the vehicle.
FEATURES AND CONTROLS
WARNING
Park Brake
Release
37