Domes-2 Protocol (Twisted Pair) - Videoswitch Vi400 User Manual

9.5.3.2

DOMES-2 protocol (twisted pair)

Specify the type of dome(s) connected to the DOMES-2 twisted pair output
9.5.3.3 Up-the-coax Protocol
Specify the type of dome(s) using "Up the coax" control
9.5.3.4 Type of control for each camera
For each dome camera, specify here whether they are to be controlled via DOMES-1
output, DOMES-2 output or by means of "up the coax" control.
9.6 Network
Remote access software for the PC is available on the internet: www.videoswitch.co.uk
9.6.1 IP Address
If the Ethernet port of Vi400/Vi600 is being used, a suitable IP address must be set. The IP
address must be unique and compatible with other devices on the network to which it
connects. If it is the only device connected to a router, the default IP address should be
suitable. Otherwise, refer to the network administrator. If you are connecting to a PC and
there is not a DHCP server, the PC will need to be programmed with a fixed IP address.
See section 10.2 for details of how to connect your Vi400/Vi600 using the Ethernet
connector.
9.6.2 Port
The default port setting (9221) should be suitable in most cases. Otherwise, refer to the
network administrator
9.6.3 Sub-Net mask
The default sub-net mask should be suitable in most cases. Otherwise, refer to the network
administrator
9.6.4 Gateway
The default gateway should be suitable in most cases. Otherwise, refer to the network
administrator
37
Digital Recorder