Connecting Up Vi600 - Videoswitch Vi400 User Manual

1.2

Connecting Up Vi600

For a standard digital recording system you will need
The Vi600 recorder
Some cameras
A video monitor (with S-video or BNC composite video input).
BNC cables
LOOP TO SPOT
LOOP TO MAIN
KEYBOARDS OF
KEYBOARD OF
NEXT UNIT
NEXT UNIT
MAIN
MONITOR
(S-VIDEO)
MAIN
MONITOR
(BNC)
IBM
KEYBOARD
SPOT
MONITOR
KEYBOARD
NOT
USED
CAMERA
INPUT 1
Connect the monitor output (MAIN) of the Vi600 to a Video Monitor using a BNC or S-
Video cable (supplied).
Make sure that the monitor termination is switched on (i.e. to 75 Ohms)
Connect a camera to Camera Input 1 on the Vi600 using a BNC cable
Connect further cameras to Inputs 2,3,4 etc
Make sure that the voltage select switch is set to suit the mains supply. The setting
required in UK and Europe is normally 230Vac.
Connect the mains power using the mains cable provided
3
LINE OUT
LINE IN
GPS
RECEIVER
ETHERNET
MAIN
TILL INPUTS
SPOT
KEYBOARD 2
SPOT
KEYBOARD 1
Digital Recorder
MICROPHONE
ISDN/PSTN
RELAYS/DOMES
RS232 PORT
MICROPHONE
INPUT
LINE LINE
OUTPUT INPUT
ALARM
INPUTS
MAINS
POWER
INPUT
CAMERA
LOOPTHROUGHS
1-16
CAMERA
INPUT 16