Table of Contents
Advertisement
3
3. Slide wind vane onto the end of the plastic
attachment located on the aluminium pole.
NOTE Use alkaline batteries for longer usage and
consumer grade lithium batteries in temperatures
below freezing.
SET UP REMOTE TEMPERATURE /
HUMIDITY SENSOR
2
1
1. Holding sensor, twist and click to the left.
2. Pull sensor away from casing.
3. Insert batteries matching the polarities (+ / -). Press
RESET after each battery change.
4
4. Insert sensor into the casing, twist and click to the
right to secure.
5. Slide temperature and humidity sensor onto the
smaller end of the sensor connector.
REMOTE UNIT ASSEMBLY
REMOTE WIND SENSOR ON EXISTING POLE
1
1. Secure the plastic base onto existing pole with U-
bolts, washers and bolts.
3
5
3
2
2. Insert the horizontal attachment bracket into the
base.
3. Using a screw, fix firmly into place.
16 4
5
4. Insert wind sensor into the top of the bracket.
5. Using screws, fix aluminium pole firmly into place.
6. Slide outdoor sensor onto bracket.
IMPORTANT For best results, point the wind vane
North.
TEMPERATURE / HUMIDITY SENSOR
MOUNTED SEPARATELY
1. Insert 4 type A screws into the holes of the sensor
connector. Screw firmly into place, i.e., fence.
SET UP RAIN GAUGE
The rain gauge collects rain and takes readings of
rainfall rate and the total rainfall over a period of time.
The sensor can remotely transmit data to the USB
communications hub.
The USB communications hub and rain gauge should
be positioned within an effective range: about 100
meters (328 feet) in an open area.
The rain gauge should be mounted horizontally about
1 meter (3 feet) from the ground in an open area away
from trees or other obstructions to allow rain to fall
naturally for an accurate reading.
4
6
Advertisement
Table of Contents
