Keying In Names - Nokia 121 Owner's Manual

Otherwise, key in a memory location number and then
press STO.
The message STORED will be shown on the display,
confirming that the information has been stored in the
memory location specified in the upper right corner of
the display.
Note: If all the memory locations are used, the display will
read NO SPACE.
If you try to store information in a memory location that is
already used, the phone will display the memory location
number and the REPLACE CONTENT? message.
If you want to replace the existing information, press STO
within 8 seconds.
If you do not want to delete the existing information, either
press CLR or wait until the message STORE NOT DONE
appears on the display. The information you tried to store
will then reappear on the display, and you can store it in a
different memory location as described above.
If you attempt to store a name that has previously been
stored, the display will read REPLACE NAME?
Note: You may also begin the memory store procedure in
alpha mode, followed by the phone number.

KEYING IN NAMES

³ Press ALPHA. The ALPHA indicator will appear on the
display to show that the phone is in alpha mode. When
you press a key, letters will appear instead of numbers.
· Select the key labeled with the letter you want. Press it
once to obtain the first letter, twice (before the ALPHA
indicator flashes) to obtain the second, and three times
(before the ALPHA indicator flashes) to obtain the third.
If you miss the letter you want, continue pressing until it is
displayed again.
» Select further letters in the same way.
If you want the same letter twice, either select it as above,
wait until the ALPHA indicator flashes once and select it
again; or select the letter, press *, then select it again.
In alpha mode the 0 key provides a space, and the 1 key
provides a "–'' (hyphen), and the "*'' allows duplicate entry
of a letter.
12