Step By Step Installation - Orion Cobalt C0500 Owner's Manual

Rear Seat
Figure 2
Figura 2
Abbildung 2
~~~~~~tiE1_-1
STEP BY STEP INSTALLATION
RearfTrunk
of Car
Step 1: Determine where the speaker will be mounted. Make sure there is a
flat area large enough for the speaker to fit properly. An uneven
mounting surface can damage the driver.
Step 2: Check to make sure the space you have chosen for the speaker will
not interfere with the operation of the vehicle.
Step 3: Using a template, mark the speaker hole with a pen.
Step 4: Cut the hole for the speaker. When using factory locations, this step
can be passed. A hole can be cut either with a pair of metal tin snips
or a hole saw corresponding to the size of the speaker listed below.
• 43/4" (120mm) hole saw (5 1/4")
• 5 1/2" (140mm) hole saw (6 1/2")
Step 5: Run the speaker wire to the speakers. Make sure to keep wires away
from sharp metal or other edges. When passing through metal ,use a
protective grommet.
Step 6: Using the template, mark the mounting holes with a pen.
Step 7: Pre-drill mounting holes using a 1/ 8 " drill bit.
Step 8: Pull the wire through the speaker opening and connect to the
speaker.
Step 9: Mount the speaker and grill in the hole using the same screws. Insert
the screws through the grill and the mounting holes in the basket.
WARNING: Window mechanisms and electrical wires may be hidden
from sight. CHECK FOR CLEARING BEFORE YOU DRILL!
4
© 2007 directed electronics-all rights reserved