JEFF ROWLAND CONTINUUM 250 Owner's Manual page 12

(5) BAL L: This button will shift the output of the amplifier towards the
left channel. Each press of the button will increase the output of left
channel by 0.5 dB and decrease the level of the right channel by
0.5 dB. A total shift of 6 dB is possible. The balance control is not
continuous; holding the button down will not continue to shift the
balance. The button must be repeatedly pressed to continue to
activate the balance shift towards the left channel.
(6) BAL R: This button will shift the output of the amplifer or speaker
outputs towards the right channel. Each press of the button will
increase the output of right channel by 0.5 dB and decrease the level
of the left channel by 0.5 dB. A total shift of 6 dB is possible. The
balance control is not continuous; holding the button down will not
continue to shift the balance. The button must be repeatedly pressed
to continue to activate the balance shift towards the right channel.
NOTE: To return the bal ance to the center or 0 dB position, press and hold the MUTE
button on the front panel of the amplifier for 3 seconds. This will reset all microproces-
sor controlled functions and return the balance position to L/R +/-0 dB.
© J e f f R o w l a n d d e s i g n g R o u p 2 0 0 9 . a l l R i g h t s R e s e R v e d .
(7) BATTERY REPLACEMENT: When the remote begins to become
weak or will not function, it is likely necessary to replace the battery.
Access to the battery is gained by removing the two Phillips head screws
that secure the back cover of the remote transmitter unit. The old battery
can be removed from the snap-on BATTERY TERMINAL and a new
battery reinstalled. A standard alkaline battery is recommended.
NOTE: When removing the old battery, wait at least 30 minutes before installing a new battery
to allow the internal circuitry to discharge completely and reset.
7
11