Hotpoint CTX14 Use And Care Manual page 6

shelves
Shelf supports at variouslevels
enable you to repositionthe shelves
to betteraccomnlodateyourvariable
inventoryof refrigeratedfoods.
Half-Widtl] S heIves
(on
modelsso equipped)
11%
1
I
~
Tilt
Up
One end rests on a molded side-
wail support: a bracket on the other
end hoois into a track on the rear
cabinet wall.
To remove, Iift the shelf up at
front, then off the support and out
of the track.
To replace, select desired shelf
height. With shelf front raised
slightly,hook the bracket'stop lug
into the track, then lower the shelf
onto the support.
fill-Width Shelves
(onmodelssoequipped)
The full-widthshelfhas wire loops
near each rear corner that fit into
pocketsin the shelf supportsto
hold the shelf securely in place.
To removethe shelf, lift the rear
of the shelf and pull forward.
To remove a full-widthshelf
when the fresh food compartment
door cannot be opened fully...
. lift the rear of the shelf. pull
fjrward and down, tilt the shelf and
take it out.
FreezerComoartn~ent
shelves
'
(onmodelssoequipped)
Some models havean ice-tray
.,. . . . . . .,-.
shelf, some have a lower-level shell
to the right of the ice tray shelf and
some models havea full-widthstep
shelf.
To removethe ice-trayshelf when
it'sthe only shelf in the freezer
compartment, lift the right side up
off hooks at top, then pull shelf to
the right to free its pins from holes
in the cabinet wall.
To removethe ice tray shelf and
the wire shelf next to-it:
1. Takethe ice-tray shelf arid lift its
right side up off hooks at top.
-.
2. Take the wire shelf and lift its
left side up off hooks at top.
3. Swing the wire shelf clear of the
hooks and the ice-tray shelf and
pull it to the left to free its pins
from holes in the cabinet wall.
4. Swing the ice-tray shelf clown
and pull it to the right to free its
pins fronl holes in the cabinel wall. :
:.
L,
~. ..—
:J, .
i.
'.' --
~. ~. .
t ,: \
\:- ~: , .
.? '-:
( 31
=:. L =-
,.,
C-2 '::
F-
- :,
f ~-=-')} ,
'<:2 ~.
~-
1'
[' i,