Hotpoint CTX14 Use And Care Manual page 14

—
Reha~ themsh FoodDoor
Washer
a. Lower the bottom socketof the
fresh food door onto the pin on the
bottom hinge. Be sure the plastic
washer is in place on the pin.
b. Insert the pin on the center hinge
into the socket in the top of the
door. Note: The center hinge must
be turned over as shown when
mounted on the left side.
e. Tilt the door toward the cabinet.
.4s the door is brought into position,
slide the hinge under the head of
the screw which earlier had been
partly driven into the outermost
hole. Insert the remaining screw,
then tighten b(]thscrews securely.
RehangtheReezer Door
.~
_— .~
Hinge Pin '-
>1
_ -----
~
Plastic
Washer 1~
a. Lower the bottom socket of the
freezer door onto the center hinge
pin. Be sure the washer is in place
on the pin.
b. Tilt the door towardthe cabinet,
lifting the top hinge so the pin fits
intothe socketon the top of the door.
c. Before tighteningthe top hinge
screws, make sure the top of the
door is level with the cabinet top
and the space between the doors is
equal across the entire front. Do
not overtightenthese screws—
tighten them until they are just
snug, then turn them in another
one-half turn.
ExaminetheDoorGaskek
Check the door gasketsall around,
making sure no gaps are visible
between the gasketsand the cabinet.
If a gap shows,try stretchingthe
gasket awayfrom the door so the
magnet in the gasketwill contact
the cabinet surface, being careful
not to dislodgethe gasket,
~