LG L2-C362LL0 Service Manual page 53

2) Connection of the cable
1. Remove the cover control from the unit by loosen-
ing the screw.
Connect the wires to the terminals on the control
board individually as the following.
Terminal on the OUTDOOR UNIT
1(L) 2(N) 3
1(L) 2(N) 3
Terminal on the INDOOR UNIT
A-UNIT
Terminal on the OUTDOOR UNIT
1(L) 2(N) 3 3 2(N) 1(L)
1(L) 2(N) 3 1(L) 2(N)
Terminal on the INDOOR UNIT Terminal on the INDOOR UNIT
A-UNIT
Terminal on the OUTDOOR UNIT
1(L) 2(N) 3 4
1(L) 2(N) 3
Terminal on the INDOOR UNIT
A-UNIT
Terminal on the OUTDOOR UNIT
1(L) 2(N) 1(L) 2(N) 3(A)
Power cord
1(L) 2(N) 3
Terminal on the INDOOR UNIT
A-UNIT
The power cord connected to the outdoor unit
should be complied with the following specifications
(Rubber insulation, type H05RN-F approved by HAR
or SAA).
3 2(N) 1(L) 1(L) 2(N)
Power cord
1(L) 2(N) 3
Terminal on the INDOOR UNIT
B-UNIT
3 1(L) 2(N)
Power cord
3 1(L) 2(N) 3
Terminal on the INDOOR UNIT
B-UNIT C-UNIT
3 4 1(L) 2(N)
Power cord
4 1(L) 2(N) 3 4
Terminal on the INDOOR UNIT
B-UNIT
3(B)
1(L) 2(N) 3
Terminal on the INDOOR UNIT
B-UNIT
CAPACITY NORMAL CROSS-
(Btu/h) SECTION AREA
~24K 2.5mm
~36K 3.5mm
~48K 5.5mm
Holder for
power supply
Cover control
Connecting cable
2. Secure the cable onto the control board with the hold-
er (clamper).
3. Refix the cover control to the original position with the
screw.
4. Use a recongnized circuit breaker between the power
source and the unit. A disconnection device to ade-
quately disconnect all supply lines must be fitted.
CAUTION
The connecting cable connected to the indoor and
outdoor unit should be complied with the following
specifications (Rubber insulation, type H07RN-F
approved by HAR or SAA).
2
2
2
Outdoor unit
Terminal block
Over 5mm
cord
Power cord
NORMAL CROSS-
Models
L2-C362LL0
Others
Service Manual 53
Installation
SECTION AREA
1.5mm 2
0.75mm 2