Test Procedures; Initial Functional Check For Tcd989/J Xenium - Philips Xenium Dual Band Service Manual

7.7.3 Plug the transformer unit into the main AC power sockets.
7.7.4 The battery charge symbol indicates the state of the charge process :
If the battery is totally discharged, the battery icon will show and start scrolling 2 to 3 minutes only after
connecting to the charger.

8.0 TEST PROCEDURES

8.1

Initial Functional check for TCD989/J XENIUM

8.1.1 Insert the Test Production Card into the SIM Reader at the back of the cellular phone and clip a charged
battery on the phone.
8.1.2 Press the «ON» button for 2 seconds at least and the LCD will show a message which contains information
of FA and 12NC. (see
8.1.3 Follow the instructions as mentioned below :
Step
1
2
3
4
•
Bars moving
•
Steady
Procedure
Press Key 1
Press Key 1 again
Press key 2
(Audio loop local effect)
Press key 2 again
Press key 3
Audio loop test (Speak to
Mic and listen echo from
Speaker)
Press key 3 again.
Press key 4 (LEDs Test)
Check for the Backlight
function in the same time.
Press key 4 again
- means the battery is being charged
- means the battery is fully charged
Observation
Continue Buzzer signal
Left corner displays 1
"LocalEffect"
" XX XX "
Left corner displays 2
"AUDIO xx xx xx "
"EEP x xx xx xx "
Left corner displays 3
Red and green LED blinking
Left corner displays 4
00
01
02
03