Rancilio Epoca Use And Maintenance Manual page 16

locations where use and maintenance is
restricted to trained personnel.
warming surface is at over 150 cm from ground. Do
not use water jets or install where water jets are
used.
In order to guarantee normal operation, the machine
must be installed in areas that the environmental
temperature is between +5°C
of not over 70%.
It does not need to be anchored to the surface and it
It is recommended to leave the area around the ma-
chine free to facilitate its use and the performance
to the electric components.
Reserve an area near the machine for the installa-
tion of the coffee grinding and dosage machine (see
relevant documentation).
Should a different softener be installed, refer to the
documentation of the relevant product.
personnel in full accordance with federal,
state and local regulations.
This equipment is to be installed to
comply with the applicable federal, state
Connections must be installed close to the machi-
ne.
Water drainage pipe 1, having a minimum internal
diameter of 30 mm, equipped with a water-trap
accessible for inspection.
Make sure that the maximum supply pressu-
re does not exceed 6.5 bar; otherwise, install
a pressure reducer.
52
(Fig.6)
Before connecting the machine ensure that the plate
network.
connected to the connection provided according to
quirements.
provisions of current legislation.
standards with protective conductor (earthing wire).
For three-phase power use a cable with 5 conductors
( 3 phases + neutral + earth).
conductors (phase + neutral + earth).
differential switch (Fig. 6) at the start of the power
cable, complete with magnetic release elements in
1). The contacts must have an opening of equal or
over 3 mm and with dispersed current protection of
-
30 mA.
Should the power supply cable be damaged
it is to be replaced by the manufacturer or by
its technical assistance service or by person
vent any risks.
-
-