Assembling The Stand (Es5 Only) - Kawai ES3 Owner's Manual

ASSEMBLING THE STAND (ES5 ONLY)

Before beginning the assembly of your ES5, read and become familiar with the assembly instructions
that follow. Then, carefully unpack the piano and check your unit against the parts shown below.
Stand (Left)
1. Fasten the stands and the speaker box
with four screws (long). The metal
brackets on the top of the stand should
face inside.
Screw (Short)
Speaker Box
Stand (Right)
Screw (Long)
Screw (Short)
– 6 –
Screw (Long) Screw (Short)
x 4
Speaker Box
Stand (Left)
Stand (Right)
2. Place the piano carefully on top of the stand
so that about one-third of the front top edge of
the stand is exposed. Then slightly lift the front
of the piano and slide it forward. Fit the pins on
top of the stand into the holes on the bottom of
the piano. Fasten the piano and the stand with
two screws (short).
CAUTION:
Be sure to secure the piano to the stand with the
screws. If you fail to do so, the piano could fall
from the stand causing damage or personal injury.
x 2
Screw (Long)