Invacare P9000 XDT Owner's Operator And Maintenance Manual page 54

SECTION 11—BATTERIES
When connecting the battery cables to the battery(ies), the battery cable(s) MUST
be connected to the battery terminal(s)/post(s) as shown in Detail "A" or Detail
"B" of FIGURE 11.7 (depending on battery type). Otherwise, damage to the battery
cable may result when installing battery terminal caps.
2. Connect battery cable(s) to battery(ies) terminal(s)/post(s) as shown in Detail "A" or
Detail "B" of FIGURE 11.7, depending on battery type:
A. NEGATIVE (-) BLACK battery cable to NEGATIVE (-) battery terminal/post.
B. POSITIVE (+) RED battery cable to POSITIVE (+) battery terminal/post.
3. Secure the battery cable(s)/ring terminal(s) to the battery terminal(s)/post(s), BLACK
to NEGATIVE (-) and RED to POSITIVE (+), with the provided 1/4-20 x 7/8-inch hex
flange screw and hex flange locknut as shown in Detail "A" or Detail "B" of
FIGURE 11.7, depending on battery type. Securely tighten.
4. Verify all battery cable(s)/ring terminal(s) are correctly installed and securely
tightened.
5. Slide terminal cap(s) down battery cable(s) and onto battery clamps.
6. Using the 11½-inch long tie-wrap, secure each terminal cap in place (Detail "A" or
Detail "B" of FIGURE 11.7).
NOTE: It will be necessary to trim excess tie-wrap in order to install the battery box top(s).
7. Install the battery box top(s).
™
P9000 XDT
CAUTION
54
Part No. 1118386