Adjusting The Shock Absorber Assembly - Yamaha XV17AWZ Owner's Manual

INSTRUMENT AND CONTROL FUNCTIONS
Adjusting the shock absorber
assembly
This shock absorber assembly is
equipped with a spring preload adjust-
ing nut.
NOTICE
To avoid damaging the mechanism,
do not attempt to turn beyond the
maximum or minimum settings.
4
Adjust the spring preload as follows.
1. Loosen the locknut.
1. Locknut
2. Spring preload adjusting nut
2. To increase the spring preload and
thereby harden the suspension,
turn the adjusting nut in direction
(a). To decrease the spring pre-
EAU14816 load and thereby soften the sus-
pension, turn the adjusting nut in
direction (b).
The spring preload setting is deter-
mined by measuring distance A,
shown in the illustration. The short-
ECA10101
er distance A is, the lower the
spring preload; the longer distance
A is, the higher the spring preload.
Use the special wrench included in
the owner's tool kit to make the ad-
justment.
1. Special wrench
1. Distance A
3. Tighten the locknut to the specified
4-17
Spring preload:
Minimum (soft):
Distance A = 42.5 mm (1.67 in)
Standard:
XV17AWZ(C)/XV17ASZ(C)
Distance A = 42.5 mm (1.67 in)
XV17ATZ(C)/XV17ATSZ(C)
Distance A = 45.5 mm (1.79 in)
Maximum (hard):
Distance A = 51.5 mm (2.03 in)
torque. NOTICE: Always tighten
the locknut against the adjust-
ing nut, and then tighten the
locknut to the specified torque.
[ECA10121]