Key To Symbols - BMW F 650 CS Repair Manual

Use
Each chapter starts with the list of contents.
The list of contents is followed by the technical data table.

Key to symbols

In this Repair Manual for the F 650 CS model, the following symbols are used; their meanings are explained
in the table.
Special instructions aimed at improving the work procedures
L
Note:
Special information on operating and inspecting the motorcycle as well as maintenance and adjustment
procedures.
e
Attention:
Instructions and precautions specifically intended to prevent damage to the motorcycle. Failure to comply
with them could invalidate the warranty.
d
Warning:
This symbol stands for precautions and measures which are essential in order to protect the rider or other
persons from possibly severe or fatal injury.
Contents
The titles of the tasks described in this chapter............. complete with page numbers
Activities
•
Activities
•
The bullet symbol indicates work steps that are described in greater detail under another headline
– Preceding activities
– A line indicates work steps that are described in greater detail under another headline or in another
chapter
The term "remove" means that:
the fastener (e.g. screw) must be backed off completely and removed
or
a component (e.g. injection rail) has to be removed to the extent that components behind it (e.g. throttle
valve rail) are rendered accessible
The term "loosen" or "slacken" means that:
the fastener (e.g. screw) must be backed off, but not removed
X
Tightening torque:
Values are stated if they differ from DIN EN 24 014 or DIN 912 ISO industrial standards.