JVC PC-X290 Service Manual page 45

3.3 Rear cabinet section
• Prior to performing the following procedure, remove the front cabinet section and rear cabinet section.
3.3.1 Removing the fuse board / A/C jack / power transformer assembly (See Fig.25 to 27)
• Prior to performing the following procedure, remove the front
cabinet section and rear cabinet section.
(1) Unsolder the two wires on the battery spring.
(2) Remove the screw P attaching the fuse board.
(3) Remove the two screws Q attaching the A/C jack.
(4) Remove the four screws R attaching the power transformer
assembly.
(5) Release the four bands setting the wire to the boss of the
rear cabinet.
(6) Remove the two screws T attaching the bracket.
Q
R
Battery spring
Power transfomer
assembly
R
Fig.25
Band
Band
Fig.26
Power tansformer assembly
T
Brackt
Fig.27
A/C jack
Fuse board
P
Band
Band
T
(No.MB200)1-11