(c) INSTALLATION OF BUILT-IN CELLAR
The cutout dimension illustrated in figure (C) allows for door swing and access to the pull-out shelves when installed
as a built-in appliance.
If installing between frameless cabinets, a ½" wide filler strip or side panel may be needed on hinge side. The filler
strip will act as a spacer between the appliance case and adjacent cabinet door swing.
(d) Reversing the Door Swing of Your Appliance
•
The unit is delivered to you with the door opening from the left side (hinge on right side)
•
The door of this appliance is capable of opening from either the left or right side. To reverse the door swing
of your cooler and open from the right side, please follow the instructions and diagram as follows:
•
Before you begin to reverse the door it is recommended to tape down shelves to avoid movement during
the process
•
It is recommended to place the Wine Cellar on it's side prior to reversing the door
•
Locate the extra set of hinges in the plastic bag containing the instruction manual
6
Figure C
The cutout depth must be 24".