Chevrolet 2012 Corvette Owner's Manual page 39

2-6 Keys, Doors, and Windows
Programming without a
Recognized Transmitter
This procedure requires three
10-minute cycles to complete the
programming process. United
States owners are permitted to
program a new transmitter to
their vehicle when a recognized
transmitter is not available.
The Canadian immobilizer
standard requires that Canadian
owners see their dealer for
programming new transmitters
when two recognized transmitters
are not available.
1. The vehicle must be off.
2. Place the new transmitter in
the glove box transmitter pocket
with the buttons facing the
passenger side.
3. Insert the vehicle key into the
key cylinder located above the
license plate.
4. Open the hatch/trunk.
5. Turn the key five times within
five seconds.
6. The DIC message displays
OFF-ACCESSORY TO
LEARN.
7. Press Acc. on the ignition
switch.
8. The DIC reads WAIT
10 MINUTES and counts
down to zero.
9. The DIC displays
OFF-ACCESSORY TO
LEARN again.
10. Press Acc. on the ignition
switch.
11. Steps 8, 9, and 10 will be
repeated two more times.
12. A beep sounds and the DIC
reads READY FOR FOB #1.
All previously known
transmitter programming has
been erased.