Hazard Warning Flashers; Turn And Lane-Change; Signals - Chevrolet 2012 Corvette Owner's Manual

6-4 Lighting
To temporarily disable Twilight
Sentinel, turn the band to
To turn Twilight Sentinel back on,
turn the band to again, then
release it.
If the Twilight Sentinel has the
headlamps turned on and you turn
the ignition off, the headlamps will
stay on for a period of time while
you leave the vehicle.
Use the Driver Information Center to
turn Twilight Sentinel on or off and
to increase or decrease the length
of the delayed illumination period.
See Personal Options under
Vehicle Personalization on
page 5 54.
The regular headlamp system
should be turned on when needed.

Hazard Warning Flashers

.
The hazard warning flashers warn
others that you have a problem.
The button is located near the
center of the instrument panel.
(Hazard Warning Flashers):
Press to make the front and rear
turn signal lamps flash on and off.
Press again to turn the flashers off.
The hazard warning flashers work
no matter what mode the ignition is
in, even if the ignition is turned off.
When the hazard warning flashers
are on, the turn signals will
not work.

Turn and Lane-Change

Signals

An arrow on the instrument panel
cluster flashes in the direction of the
turn or lane change.
Move the lever all the way up or
down to signal a turn.
Raise or lower the lever until the
arrow starts to flash to signal a lane
change. Release the lever and the
turn signal automatically flashes
three times. If more flashes are
desired, continue to hold the lever.