Advertisement
Mount Car Show Navigation into Dash
Be sure to fully engage all connectors
Insert Car Show Navigation System Into Dash and mount
using OEM 4 x 10mm (2 Left/2 Right) screws
Re-install upper vent assembly and be sure to connect all
Re-Install Lower Trim Components
Carefully re-install lower dash components
Verify Unit Operation
Power on unit to verify full operation
Insert a DVD to confirm the Video Disable
Circuit is properly Operating.
The Brake Wire must be connected to the Park Brake
Indicator Wire to complete a ground when the brake is
ENABLE INSTALLER SETTINGS
You will need to select certain Installer Setting based on any Optional Equipment that you may have
Launch the Installer Setting Screen
From any screen with the Menu Button, follow these steps
to display the Installer Setting Screen, select:
1) From any Screen, select "Menu"
2) From the Menu Screen, select "Settings"
3) Press "Keypad," Press "7253" and "Enter"
Car Show
Installation Guide
Car Show Installation Guide
harnesses
engaged.
installed
CAUTION
STEP
5
Copyright 2012 All Rights Reserved
Page 6
Advertisement
