Advertisement
Unplug Electrical Connections
Carefully remove all harnesses from rear of OEM radio
*JBL Audio equipped vehicles will require additional part #
DP-TYJBL1 audio interface
Remove Factory Brackets/Clips
Remove factory brackets and clips from OEM radio
(8 x 10mm bolts 4 Left/4 Right)
Re-Install Factory Brackets/Clips on Car
Show Unit
Re-install factory brackets/clips on Car Show unit
(8 x 10mm bolts 4 Left/4 Right)
LOCATING REMOTE COMPONENTS
You will need to mount the GPS and Optional Satellite Radio Antennas on the exterior of the vehicle.
And mount the iPod Interface Connector in the vehicle. The following steps will help guide you
Use Caution around SRS Components
It is the installer's responsibility to ensure that the safety
equipment in the vehicle is NOT adversely affected by installation
of this system. Ensure that the routing of the harnesses do NOT
obstruct airbags, SRS or other safety devices.
Mount the GPS and Sat Radio antenna in a
location on the exterior of the Vehicle
Route the GPS harness away from other power harnesses in the
This will help to ensure optimum performance of the GPS
Car Show
Installation Guide
Car Show Installation Guide
through this process.
vehicle.
system.
CAUTION
STEP
3
Copyright 2012 All Rights Reserved
Page 4
Advertisement
