Advertisement
PREPARING FOR THE INSTALLATION
Before you start, please read these critical steps below
BEFORE YOU START THE INSTALLATION,
READ THIS GUIDE!
CHECK THE BATTERY
Test the battery voltage to make sure it's fully charged to a
minimum of 12.8 VDC
This only takes seconds and can save hours of
troubleshooting later.
TURN THE VEHICLE
Keep the Vehicle Off during the installation to avoid setting
various Vehicle Fault sensors
Keep the Vehicle OFF during the
Failure to follow this may cause the AIRBAG FAULT
SENSOR to become enabled. Dealer Service Departments
charge a significant fee to reset the Fault Sensor.
Car Show
Installation Guide
Car Show Installation Guide
OFF
installation
STEP
1
Copyright 2012 All Rights Reserved
Page 2
Advertisement
