Table of Contents
Advertisement
5.
Power on the camera with the correct power
supply and make sure that the red Power
LED is lit.
6.
If there is a video picture visible on the
monitor, you may adjust focus and zoom. If
there is no video picture on the monitor,
please check the following.
• Is the red Power LED of the camera lit?
• Is the monitor powered on and is the level
of contrast and brightness set correctly?
• Is the camera connected properly to the
monitor (also check the resistor settings)?
• Manual iris lenses: is the iris fully open?
• Auto-iris lenses: is the auto-iris connector
connected to the camera and is the lens
drive level fully up?
• Is the illumination where the camera is
located sufficient for this camera model?
7.
Mount the camera and align it. Please use
a housing also to protect the camera
against dust. In areas that do not comply
with the specified environment ratings, the
camera has to be installed within a housing
which ensures that the given environment
ratings are observed.
8. Auto-iris connector (7)
To connect an auto-iris lens that requires a video
drive signal, the auto-iris connector is needed.
Apply this connector to the cable of the lens. The
following figure shows the correct wiring.
Pin
1
2
3
4
Connector
12V DC max.
Video signal
Not used
GND
1
2
7
3
4
Advertisement
Table of Contents
