Quick Start Guide - Kambrook KCE240 Instruction Booklet

Quick Start Guide

Turning the heater on
Plug the cord into a 230V or
240V power point and switch on.
Setting the heating mode
POWER
MODE
TEMPERATURE
Pressing the 'MODE' button
once will set the heater into
high heat mode (2000W).
Setting the variable temperature
POWER
MODE
TEMPERATURE
To use the variable thermostat,
press the 'MODE' button twice
to set the heater into AUTO
mode (2000W).
8
Switch the heater on using the
'ON/OFF' switch on the back of
the heater.
POWER
SWING
MODE
TIMER
Pressing the 'MODE' button
twice will set the heater into
AUTO mode. Auto mode allows
you to adjust the temperature
settings to suit the desired
temperature.
POWER
SWING
MODE
POWER
TEMPERATURE
TIMER
Set the desired temperature by
adjusting the 'TEMPERATURE'
(+) to increase the temperature
and the (-) to decrease the
temperature. The heater will
now cut in and out to maintain
chosen 'TEMPERATURE'.
Press the 'POWER' button to
activate heating. The heater
will be in low heat mode
(1100W) and the current room
temperature will appear on the
LED screen.
POWER
TIMER
TEMPERATURE
Pressing the 'MODE' button
three times will set the heater
into the FAN mode, and the
LED screen will show the current
room temperature. FAN mode
is for fan-only operation with no
output of heat.
Setting the oscillation
SWING
TIMER
MODE
TEMPERATURE
Pressing the 'SWING' button will
allow the heater to oscillate
side to side. To stop the
oscillation, press the 'SWING'
button again.
POWER
MODE
TEMPERATURE
SWING
MODE
TEMPERATURE
SWING
TIMER
TIM
S
TIMER