Using Your Kambrook Heater; Before First Use; Turning Your Heater On - Kambrook KCE240 Instruction Booklet

Using Your Kambrook Heater

Before First Use

Remove your heater from its carton
and associated protective wrapping.
Unwind the cord to its full length and
remove any protective cardboard
or foam that may have been used
to minimise transportation damage.
Place the heater on a firm, level
surface in a stable upright position.
Visually inspect the air inlet and
outlets to ensure no foreign material is
blocking these areas. The heater must
always be operated with the rear air
filter in position.

Turning Your Heater On

Plug the cord into a 230V or 240V
electrical outlet. Be sure the plug
fits tightly as a loose fit will cause
overheating and damage the plug.
NOTE: To avoid an electrical
circuit overload, it is
recommended that no other
appliances are plugged into the
same circuit with your heater
when you switch the unit on.
Turn the heater on by pressing the
'ON/OFF' switch at the rear of the
unit to the 'ON' position. This will
automatically allow the control
panel to display the current room
temperature.
To start the heater working, press the
heater on by pressing the 'POWER'
button once; the unit will be in the
LOW heat MODE (1100 watts).
Pressing the 'MODE' button once at
this stage will set the heater into the
HIGH heat mode (2000 watts), and
the current room temperature will
appear on the LED screen.
Pressing the 'MODE' button again will
set the heater into the AUTO mode.
AUTO mode can be used to maintain
your desired room temperature.
Pressing the 'MODE' button three
times will set the heater into the FAN
mode, and the LED screen will only
show the current room temperature.
NOTE: FAN mode is for fan-only
operation with no output of heat.
Pressing the 'MODE' button again
will cause the heater to go back into
the LOW heat mode (1100W).
To turn the heater OFF, press the
'POWER' button. Turn the power 'ON/
OFF' switch to the 'OFF' position
and turn off at the power outlet and
remove the plug from the power outlet.
NOTE: Press the 'POWER' button
to turn the heater OFF. The
fan may continue to run for
approximately 30 seconds to
cool the heater. Always wait
for the fan to stop cooling the
heater before switching off the
power 'ON/OFF' switch and turn
off at the power outlet.
NOTE: There is a tip-over
switch fitted to this heater. If
the heater is tipped over, it will
automatically turn OFF. Once
placed back into the upright
position, the heater will be in
standby mode and the settings
will need to be selected again.
9