Setting Up The Channel List; Using Auto Program - Sony KV-30XBR910 Service Manual

Setting Up the Channel List

Using Auto
Program
z
To exit the Tilt Correction
and Vertical Correction screens,
press the MENU button.
z
For more details on using
Auto Program, see page 84.
For more details on using Tilt
Correction and Vertical
Correction, see pages 89-90.
After you finish connecting your TV, you need to run Auto Setup to
set up your channels. The Auto Program screens appear when you
turn on your TV for the first time after hooking it up.
To run Auto Program the first time you turn on your TV
1
Press to turn on the TV.
POWER
The Initial Setup screen appears.
2
Using the joystick on the remote control, move the highlight to
the desired language, then press
3
The next screen instructs you to connect your cable/antenna.
Check that you've connected your signal source as described on
pages 16 to 22.
To start Auto Program, move the joystick to highlight
press .
Auto Program automatically creates a list of receivable channels.
When Auto Program is finished, the Tilt Correction screen
appears.
4
Move the joystick
choose a correction between +7 and -7.
When finished, press
5
Move the joystick
You can choose a correction between +5 and -5. When finished,
press .
The lowest numbered channel is displayed.
To reset the TV to factory settings
1
Press to turn on the TV.
POWER
2
Hold down on the remote control.
RESET
3
Press on the TV. (The TV will turn itself off, then back
TV POWER
on.)
4
Release .
RESET
to select that language.
to correct any tilt of the picture. You can
B b
. The Vertical Correction screen appears.
V v to make a vertical correction to the picture.
and then
Yes
41