Related Manuals for CityCom CityCom CCR 502
Summary of Contents for CityCom CityCom CCR 502
- Page 1 Operating manual Order no.: 20210011 / 20210017 20210012 / 20210018 ® CityCom Communication systems...
-
Page 2: Table Of Contents
SAFETY INSTRUCTIONS ... 3 2. CONNECTIONS ... 4 OPERATION ... 5 3.1..5 OCAL CONTROL 3.2. UNCTIONS OF THE REMOTE CONTROL 3.3..6 ROGRAMME 3.3.1 ROGRAMME SELECTION WITH THE NUMERICAL BUTTONS 3.3.2 AST PROGRAMME WITH THE 3.3.3 APPER FUNCTION WITH THE 3.3.4 ROGRAMME MANAGEMENT WITH... -
Page 3: Safety Instructions
1. Safety instructions The following section contains important information regarding operation, place of installation and connection of the receiver. Read these instructions carefully before putting the unit into operation. Extended absence / thunderstorms Always switch the unit off via its mains switch on the right side of the front panel during periods of extended absence or at the onset of thunderstorms or withdraw the mains plug from the outlet. -
Page 4: Important Notes For Siting And Installation
Important notes for siting and installation Place of installation Every electronic device generates heat. The rise in temperature, however, lies within a safe range. Slight colour changes may occur to sensitive furniture surfaces and veneers over the course of time due to the constant effect of heat. -
Page 5: Operation
3. Operation 3.1. Local control Open (and close) the flap on the front panel of the unit by pressing the dotted area (left). The local control consists of the buttons [STANDBY], [▲] and [▼] for switching the programmes (up/down), as well as [ - ] and [ + ] for adjusting the volume. STANDBY To switch between radio and TV, quickly press the button [STANDBY] and within one second the [ - ] button for radio or the [ + ] button for TV operation. -
Page 6: Programme Selection With The Numerical Buttons [0...9], [▲] , [▼] And List
3.3. Programme 3.3.1 Programme selection with the numerical buttons [0...9], Setting a programme is carried out by direct entry of the programme number with the numerical buttons (0 is also a programme number). Switch to the next / previous programme with the [▲] / [▼] buttons. After pressing the [OK] button two times, a list is displayed which is arranged according to programme numbers. -
Page 7: Tv / Radio - Switch-Over
All programmes from the programme pool are also saved in the favourite list 0 = „ALL“ upon delivery. The favourite list F0 = ALL contains all the programmes known thus far for satellite receivers. Some of the programmes from the satellites Astra 19 and Eutelsat Hotbird are additionally contained in different favourite lists. -
Page 8: Timer
3.7. Timer The „timer programming“ menu is called up by pressing the [ alternatively entered with TV or radio programmes. Note: Keep in mind, that the video recorder must also be set to the same recording time. Note: Please make sure, that no remote control commands are made during the recording time, otherwise unwanted OSD displays will also be recorded. -
Page 9: Epg - Programme Information (Basis Navigator)
3.8. EPG – Programme information (Basis navigator) In the EPG (Electronic Programme Guide), information about the current and following programmes is displayed. The magnitude of this programme-accompanying information is determined by the respective programme provider and varies from programme to programme. Many programmes are transmitted without usable supplementary information (SI data). -
Page 10: Menu Structure
4. Menu structure 4.1. Programmes 4.1.1 Favourite list Access the main menu by pressing [M], and then press the [OK] button twice. Sorting, exchanging, copying and deleting programmes – all in one menu! [ i ] Selects one of the favourite lists 0...9. Selects the satellite (e.g. -
Page 11: Changing Names Of The Favourite Lists
Deleting: Move the programme, which is to be deleted, to the red bar using the [▼] [▲] buttons (or by entering the programme number). Place it in the centre field by pressing the [ Exit the menu with the [E] button and ‚delete‘ with the [OK] button – finished! Note! „Deleted“... -
Page 12: Programme Pool
4.1.3 Programme pool The programme pool contains all programmes in alphabetical order. Press the [M] button to select the satellites. Press the [TV] button to select free or encrypted programmes. In „All Free“ („All CA“) you will find all the free (all unencrypted) programmes of the selected satellite, and also the new free or encrypted programmes after a satellite search. -
Page 13: Parental Lock
4.1.4 Parental lock The 5-digit password (PIN) is set to 00000 at the factory. a) Changing the password (PIN) Select the „Parental lock“ menu with the [4] button in the main menu „Programme!“ Select the entry field {PIN} by using the [2] button or the [▼] button, and activate it by pressing [OK]. Enter in the ‚old‘ and your ‚new‘... -
Page 14: Search
4.2. Search 4.2.1. Satellite search The satellite search occurs via all frequencies of the selected satellite. Select the desired settings in the order of the menu: The selection of the individual parameters is carried out after the activation with the [OK] button and then with the [►] or [◄] button. -
Page 15: Satellite
4.3. Satellite The satellite ASTRA is set at the factory. The other 7 satellites, e.g. Hotbird, are pre-programmed. For extending your receiving system, you can make the required settings for the 7 pre-programmed satellites in the ‚Satellite‘ menu. Activate the desired satellite number, e.g. with the numerical buttons [1...8], and call up the entry menu with the [OK] button. -
Page 16: Menu Language
4.4.2. Menu language Select the language. The menu language can be switched between {German } and {English} . Select the font. The automatic changeover of the font is defined in the DVB standard – Unfortunately not all broadcasting institutes keep to this standard, and characters in a text can appear in the wrong font. -
Page 17: Lnb Settings
DiSEqC signal is repeated 1 time. { 2 } the DiSEqC signal is repeated 2 times. „UFO mini“ and „UFO micro“ are specific SAT systems from the company Kathrein. Please take the required parameters from the respective operating manuals. (1) UFO mini {OFF } / {ON} (2) Remote Freq. -
Page 18: Download-Over-Air (Software Update Via Satellite)
4.4.6. Download-over-air (Software update via satellite) In the submenu „Download“ you can individually download operating software and programme lists of your receive via the satellite ASTRA (Update via download-over-air). To do so, your receiving system must be aligned to the satellite ASTRA 19.2° east. Keep in mind, that your individual programme assignment in each of the ten favourite lists in TV and RADIO are overwritten by the current programme lists when updating the programme lists! Start the software download in the INSTALLATION menu after selecting the menu (6) -
Page 19: Ca (Conditional Access) = Encrypted Programmes (Ccr 512)
4.5. CA (Conditional Access) = Encrypted programmes (CCR 512) 4.5.1 General information To receive encrypted programmes, you need a Common Interface CA module (CAM) and a Smartcard from your service provider. Note, that the CA modules with the respective Smartcards only decode programmes from your service provider. -
Page 20: Glossary
Glossary Band Frequency band of a satellite. Low-band and high-band (Conditional Access) stands for encrypted programmes. CVBS Composite Video Burst Sync : Video-Standard for TV or VCR units DiSEqC Digital Satellite Equipment Control Digital Video Broadcast Electronic Programme Guide Favourite list List of selected programmes from the programme pool. Free Freely received (unencrypted) programmes. -
Page 21: Technical Data
Timer for 8 events (TV or radio). · Optimal alignment of the parabolic antenna according to signal strength and figure of merit of reception. · Teletext via TV. · Prepared for UFO mini, UFO micro (Kathrein specific). - 21 -... -
Page 22: Software Update
RF range · Sat IF frequency range · Input level ranges · Reception threshold (EB/NO) TV system digital · Modulation, FEC, demultiplexer · Video definition · Input data rate · Bit rate · Video - voltage/impedance · S / N ·... - Page 23 ® CityCom Communication systems, a company of the Kathrein group, Schlierseestraße 4, 83022 Rosenheim...
Need help?
Do you have a question about the CityCom CCR 502 and is the answer not in the manual?
Questions and answers