License Plate Lamp - Cadillac 2014 SRX Owner's Manual

10-32 Vehicle Care
6. Disconnect the wiring harness
connector from the back-up bulb/
socket assembly.
7. Turn the back-up bulb socket
counterclockwise to remove it
from the taillamp assembly.
8. Install a new bulb/socket
assembly into the taillamp
assembly, and turn the bulb/
socket clockwise until it clicks.
9. Reinstall the taillamp assembly
and tighten the screws.
10. Reinstall the taillamp cover by
snapping it into place.
11. Push the push pin to secure
the taillamp cover.

License Plate Lamp

To replace one of these bulbs:
1. Open the liftgate. See Liftgate
on page 2-13.
Passenger Side Shown, Driver
Side Similar
2. Push the left end of the lamp
assembly toward the right.
3. Turn the lamp assembly down to
remove it from the liftgate.
4. Turn the bulb socket (1)
counterclockwise to remove it
from the lamp assembly (3).
5. Pull the bulb (2) straight out of
the bulb socket.
6. Push the replacement bulb
straight into the bulb socket and
turn the bulb socket clockwise to
install into the lamp assembly.
7. Turn the lamp assembly into the
liftgate, engaging the clip side
first.