License Plate Lamp; Replacement Bulbs - Cadillac Escalade EXT 2013 Owner's Manual

10-30 Vehicle Care
1. Open the tailgate. See Tailgate
on page 2 14.
2. Remove the two screws from the
taillamp assembly.
3. Pull the taillamp assembly
rearward until disengaging the
two outer pins of the taillamp
assembly from the vehicle.
4. Turn the bulb socket
counterclockwise to remove it
from the taillamp assembly.
5. Pull the bulb straight out from
the socket.
6. Press a new bulb into the bulb
socket.
7. Reinstall the socket into the
taillamp assembly by turning the
bulb socket clockwise until it
clicks.
8. Reinstall the taillamp assembly
making sure to line up the pins
with the vehicle and tighten the
screws.

License Plate Lamp

A. License Plate Lamp Housing
B. Bulb
C. Bulb Socket
To replace one of these bulbs:
1. Using a small flat-bladed tool,
insert the blade end at the back
edge of the rear license plate
lamp housing (A).
2. Gently push forward while lifting
the back edge of the lamp
housing from the bumper
opening.
3. Turn the bulb socket (C) one
quarter turn to release the bulb
socket from the lamp
housing (A).
4. Pull the bulb (B) from the bulb
socket (C).
5. Reverse the steps to install.

Replacement Bulbs

Exterior Lamp
Back-up Lamp
License
Plate Lamp
Bulb
Number
7441
168