Gamma 8800 Els Owner's Manual page 8

ASSEMBLY INSTRUCTIONS
Turntable and Mounting System
Installation
To install the turntable remove the four nuts
holding the mounting bolts in place during
shipment. Position the turntable over the
turntable pin and align the bolts with the
holes in the flange. Secure them with the
included allen wrench.
CAUTION: If the mounting bolts are removed
or fall out during assembly be sure that the
bolts pass through the spacer inside the
turntable before securing the turntable to
the turntable pin.
String Clamp Installation
The post of the string clamp and tube of the
string clamp base are treated with grease to
provide protection against corrosion during
shipping and while in storage. Remove any
excessive grease with a clean cloth prior to
use. The post and tube may also be cleaned
with isopropyl alcohol. After this type of thor-
ough cleaning, the post and tube should be
treated with a light coating of machine oil to
protect the surfaces against corrosion and
to ensure smooth operation.
8