Using Setup - Uniwide XtremeServer 2544 User Manual

Uniwide xtremeserver 2544 2u rackmount server
Table of Contents

Advertisement

4.1.3 Using Setup

In general, you use the arrow keys to highlight items, press <Enter> to select, press <Esc> to quit. The following table
provides more details about how to navigate in the Setup program using the keyboard.
Key
Up Arrow( ) Key
Down Arrow( ) Key
Left Arrow( ) Key
Right Arrow( ) Key
Esc key
Enter Key
PgUp Key
PgDn Key
F1 Key
F2/F3 Key
F7 Key
F8 Key
F9 Key
F10 Key
Home
End
Esc
NOTICE
The BIOS does NOT automatically save values that you have modified. If you do not save your values
before you exit the BIOS Setup Utility, all your changes will be lost.
If after making and saving system changes with the BIOS Setup Utility, you discover that your computer
is no longer able to boot, the AMI BIOS supports an override, which will reset your system to the
Failsafe defaults. If that fails, it is possible to manually clear the present CMOS information through
the "Clear CMOS Header" on the motherboard (Refer to Jumper Settings for more information).
The best advice is to ONLY alter settings which you thoroughly understand. The default settings have
been carefully chosen by AMIBIOS to provide the maximum system performance and reliability.
Even a slight change to the chipset setup may cause potential and unpredictable failure to the system.
Function
Move to the previous item
Move to the next item
Move to the previous item
Move to the next item
In the Submenu: Exit the submenu.
In the BIOS main category: Quit Without saving changes.
Select the item. A pop-up selection will display on the screen to set the item value.
Previous page on Scrollable menus or jump to the first interactive item listed.
Next page on Scrollable menus or jump to the last interactive item listed
General Help on Setup navigation keys. Press <F1> key to pop up a small help
window that describes the appropriate keys to use and the possible selections for
the highlighted item. To exit the Help Window, press<ESC> key or <F1> key
again.
Change colors
Discard changes
Load failsafe defaults
Load optimal defaults
Save and Exit
Go to top of screen
Go to bottom of screen
Exit
29

Advertisement

Table of Contents
loading

Table of Contents