Before Calling Service - icetro SSM-180 User Manual

11. Before Calling Service

Failure
If power is not supplied
The spiral rotation is
stopped.
(Noise is generated.)
The material does not
come out from the slush
supply.
The granita is not
formed.
While operation, water
flowing sound is heard.
It is too much frozen.
24
Cause
1. Power is not supplied from
the outlet.
2. The power switch is turned
off.
3. The fuse is disconnected.
Low sugar level in the material.
(The spiral is frozen.)
Deformation of the spiral and canister.
(It can happen when hot water (80 or
above) is used while cleaning and sterilizing
the product.)
Spiral rotation shaft wear (wear of
the part that meets the spiral
rotation shaft in the middle of the
cylinder)
The material level is too low.
The material is too much frozen.
1. The material level is too low.
2. The sugar level is set to
Weak (Level 1).
3. It is set to Stop or
Refrigeration.
The sound is heard when the
refrigerant flows.
The freezing switch is turn on
continually.
Action
1. Check the outlet connection
status.
2. Turn on the power switch.
3. Replace the fuse.
Turn off the power switch and melt
the ice.
(At this time, do not use a sharp
tool such as ice pick.)
After that, retry.
Replace the spiral and canister.
Replace the spiral.
Fill the material up to three litters.
Adjust the control screw on the cover of
the motor (on the rear of the product).
1. Replace the material
(sugar level: 13 to 15%)
2. Connect the cord of the cap.
3. Set it to Freezing.
Normal operation
Adjust the freezing and refrigeration
switch to have optimal temperature. In
this case, set the switch to Refrigeration
or Stop.