Advertisement
Table of Contents
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Micom 2BT
Summary of Contents for Micom 2BT
- Page 1 MICOM-2BT MICOM-2BT MICOM-2BT MICOM-2BT Trunk Mount Trunk Mount Trunk Mount Trunk Mount HF-SSB Transceiver HF-SSB Transceiver HF-SSB Transceiver HF-SSB Transceiver Trunk Mount Installation Instructions 68MB000006 Supplement to MICOM-2 HF-SSB Transceiver Owner’s Manual 68P02941C60-O...
- Page 2 MICOM-2BT Trunk Mount Installation General This document describes installation of the MICOM-2BT radio in the trunk of a vehicle. The instructions cover only aspects which are specific to trunk installation. All other installation instructions are in the Installation section on pages 25-33 of the MICOM-2 HF-SSB Transceiver Owner’s Manual...
- Page 3 MICOM-2BT Trunk Mount Installation Installation In the MICOM-2BT Trunk Mount model, the control head, speaker, and microphone are installed in the passenger compartment. The control head can be installed overhead or under the car’s front panel, the radio transceiver is installed...
-
Page 4: Installation Notes
MICOM-2BT Trunk Mount Installation Installation Notes: 1. Overhead installation of the control head (#1 in Figure 2), is recommended rather than front installation (#2 in Figure 2), because the vehicle roof protects the control head from direct sunlight. 2. When the ATU is located in the trunk or on the spare wheel, one or two cables must be run across the length of the vehicle (depending on whether the battery is located in the rear or front section of the vehicle).
Need help?
Do you have a question about the 2BT and is the answer not in the manual?
Questions and answers