Table of Contents
Advertisement
Regulatory compliance information
FCC C
B
LASS
This Barco Graphics Controller complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with manufacturer
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
§
Increase the separation between the equipment and receiver.
§
Connect the equipment into an outlet on a circuit different from
§
that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
§
The use of shielded cables for connection of the monitor to the display
controller is required to ensure compliance with FCC regulations. Changes
or modifications to this unit not expressly approved by Barco could void
the user
48
Display Controller User Guide
Advertisement
Table of Contents
