Table of Contents
Advertisement
Conference CloneView
Overview
This application allows the user to clone outputs from 1 or 2 displays to a
third display or projector attached to the same display controller. The
cloned image will be scaled to fit the resolution of the target display. The
application supports zooming and panning for ease of viewing.
Supported display controllers
MXRT-1450, MXRT-2400, MXRT-2500, MXRT-4500, MXRT-5400, MXRT-
5450, MXRT-5500, MXRT-5550, MXRT-7400 & MXRT-7500
Configuration
1
Start the Conference CloneView application either from the
desktop icon or from Start -> Programs. -> Barco, this will display
the configuration window.
2
Select the display controller that is connected to the display(s) you
would like to clone from the drop down list. You can only clone
displays connected to the same display controller. Click on
display controller.
3
Select up to two source display(s) to clone from, and the target
display where the cloned image will display, and click on the
downscaled to fit the cloned display, while maintaining the
original aspect ratio. Select
image to fit the cloned display
fill
Display Controller User Guide
tly selected
41
Advertisement
Table of Contents
