Table of Contents
Advertisement
Installation procedure
The following instructions will take you step by step through the
installation of the B
Wear a grounded, protective ESD strap when handling or
during installation of the display controller. Electrostatic
charges can damage the display controller.
1
If you are not going to use your old display controller, uninstall its
drivers and software if you have not already done so.
2
Turn off the computer, display(s), and other peripheral devices.
3
Unplug the computer
the back of your computer.
Wait approximately 20 seconds after unplugging the
power cord before disconnecting a peripheral or
removing a component from the motherboard to avoid
possible damage to the motherboard.
4
Remove the computer cover. If necessary, consult your computer
manual for instructions.
5
If necessary, unscrew or unfasten and remove any existing display
controller(s) from your computer.
If you are using a motherboard containing an on-board
graphics solution and do not intend to use it as part of a
multiple-display setup, disable it either in the computer
System Set-up utility (BIOS) or the Windows device
manager.
6
Locate the appropriate slot and, if necessary, remove the metal
back-plate cover(s).
7
Align the B
with the slot(s) and press it(them) in firmly until the card(s) is(are)
fully seated.
D
C
ARCO
ISPLAY
ONTROLLER
D
C
ARCO
ISPLAY
ONTROLLER
(
) for your B
S
(
) for your B
S
Display Controller User Guide
D
S
ARCO
ISPLAY
YSTEM
from
D
S
ARCO
ISPLAY
YSTEM
11
.
Advertisement
Table of Contents
