Table of Contents
Advertisement
dE
gB
F
Nl
C
8
To connect a powder or solid detergent dispenser:
– Remove the rear panel.
– Drill a hole through the inner tank wall appropriate to the required
connection diameter (see fig.).
– Screw up tightly the dosing connection with tank wall.
– Connect the plug (C) of the wire harness with the dosage pump
(max. 100 VA).
– Swing control box back into position and put panel(s) back into place.
Switch on main switch at site or put the plug in.
– Dispenser adjustment see chapter 6.1
Conductivity probe:
– Conductivity probe should be installed at the flat part of tank bottom
(see fig.).
– The hole size should be appropriate to the conductivity probe.
AG-21213-F-09-09
Hide quick links:
Advertisement
Table of Contents
